6External device connectors

REMOTE 2 PARALLEL I/O(50P)

1 REMOTE 2 PARALLEL I/O(50P) connector

REMOTE 1-IN(9P) CONTROL PANEL

2 CONTROL PANEL connector

REMOTE 1-OUT(9P)

VIDEO CONTROL

3 VIDEO CONTROL connector

RS232C

4 OPTION connector

(OPTION)

5 REMOTE 1-IN(9P) connector

6 REMOTE 1-OUT(9P) connector

7 RS-232C connector

1REMOTE 2 PARALLEL I/O(50P) connector (D-sub 50-pin)

Connect remote control signals from an external device.

For details, refer to the Installation Manual.

2CONTROL PANEL connector (round type, 10- pin)

In addition to the lower control panel, a similar control panel can be connected to this unit. To connect such a second control panel, use this connector. When two control panels are connected, use the PANEL SELECT switch on the switch panel (see page 2-12)to specify which control panel will control this unit.

3VIDEO CONTROL connector (D-sub 15-pin) For remote control of the internal digital video processor, connect an optional BVR-50/50P Remote Control Unit.

Always power off this unit before connecting the remote control unit.

4OPTION connector (D-sub 9-pin) Not used.

5REMOTE 1-IN(9P) connector (D-sub 9-pin) When using this unit together with an MSW-A2000/ A2000P/M2000/M2000P (recorder) or a D-1,D-2, or Betacam VTR, and a BVE-seriesBVE-900/910/2000/ 9000/9000P/9100/9100P or other editor, connect the optional 9-pin remote control cable from the other unit to this connector.

Depending on the setting of setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-OUT(9P) connector.

6REMOTE 1-OUT(9P) connector (D-sub 9-pin) This provides the loop-through output for remote control signals from the REMOTE 1-IN(9P) connector.

Depending on the setting of setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-IN(9P) connector.

7RS-232C connector (D-sub 9-pin)

Use this for monitoring and diagnosis of the state of this unit from an external computer, using ISR (Interactive Status Reporting).

7Time code output section

TIME CODE

OUT

TIME CODE OUT connector

TIME CODE OUT connector (XLR 3-pin, male) This outputs the playback time code.

By setting setup menu item 606, you can also output the time code from the internal time code generator locked to the playback time code.

Parts of Function and Location 2 Chapter

Chapter 2 Location and Function of Parts 2-15