Chapter6
To make comment settings
Proceed as follows to make comment settings.
1 Select a clip.
2 Select comment.
3 Press the F2 (SELECT) button.
The unit enters clip data modification mode.
4 Press the F2 (MODIFY) button.
The data entry area begins to flash, and the data can be set.
5 Enter a character by rotating the MULTI CONTROL knob.
6 Press F4 (t) button to move to the next character place.
7 Repeat steps 5 and 6 until you have entered the entire comment.
To delete characters
Press the F3 (T) or F4 (t) button until the character that you want to delete starts flashing, and then press the F5 (DELETE) button.
To insert characters
Press the F3 (T) or F4 (t) button until the character place after the place where you want to insert starts flashing, and then press the F6 (INSERT) button.
8 Press the F2 (OK) button.
The comment is confirmed and the unit returns to clip data display mode.
Undo function
The undo function cancels all modifications and returns the data to the state it was in when first read. Press the F5 (UNDO) button in clip data display mode. A confirmation message appears. Press the F2 (OK) button to execute the undo and cancel all modifications to the data.
Resume function
If you have not modified any data since the last execution of the undo function, you can press the F5 (UNDO) button again. The button functions as a resume button, which cancels the immediately preceding undo.
Press the F5 (UNDO) button in clip data display mode. A confirmation message appears. Press the F2 (OK) button to execute the resume and cancel the immediately preceding undo.