1)By setting
2) A track mark is added at the point where you press X again to resume r the remainder of the track will be
3)If you
If the recording does not start
•Make sure the recorder is not locked (pages 20, 74).
•Make sure the MD is not
•Premastered MDs cannot be recorded over.
For models supplied with the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
Notes
•“Data Save” or “TOC Edit” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display.
•The lid does not open until“TOC Edit”
z
•LINE IN (OPT) jack is for both digital and analog input. The recorder automatically recognizes the type of line cable and switches to digital or analog input.
•The recording level is adjusted automatically. To adjust the level manually,“Adjustingsee
the recording level manually (Manual recording)” (page 36).
•You can monitor the sound during recording. Connect the supplied headphones/earphones
with remote controli/LINEtoOUT
adjust the
disappears in the display.
•If the power supply is disrupted (i.e. the battery is removed or becomes exhausted or the AC power adaptor is disconnected) during a recording or editing operation, or while
“TOC Edit” appears in the display, then it will not be possible to open the lid until power is restored.
•You can make digital recording only from an optical type output.
•When recording from a portable CD player, set the CD player to pause, and then do the recording procedure on the recorder.
•Note the following when recording from a portable CD player:
∗Ελεχτρονιχ Σηοχκ Προτεχτιον
24