zTo stop recording
To temporarily record without recordin Pressx.
the current contents, press END SEARCH
before the start ofzrecording. The rec | |
begin | |
set to “From Here” (factory setting). The | For more informatio |
remaining recordable time on the disc will |
|
appear in the display when you press END SEARCH.
Notes
• The setting will remain even after the power is | 1 |
turned off. |
•If you start recording while the recorder is in
from the point at which it is paused. | 2 |
•When the group mode is turned on, recording always starts after the current contents.
While the recorder is recording or stopped, press the jog dial.
Turn the jog dial“MICuntilSENS” flashes in the display, and then press the jog dial.
Stereo microphone (not supplied)
3 Turn the jog dial“SENSuntil HIGH” or “SENS LOW” appears in the display.
When recording a soft or a sound in the distance, set to “SENS HIGH”. When recording a loud or a sound at close range, set to “SENS LOW”.
4 Press the jog dial.
Notes
REC
to MIC (PLUG IN POWER)
1 Connect a stereo microphone to MIC (PLUG IN POWER) jack.
•You cannot record through the microphone while an optical cable is connected to the LINE IN (OPT) jack. In this case, disconnect the optical cable from the LINE IN (OPT) jack. The recorder automatically switches input in the following order; optical input, microphone input, and analog input.
•The microphone may pick up the operating sound of the recorder itself. Use the microphone away from the recorder in such cases. Do not use a microphone with a short connector, as this may cause the operating sound of the recorder to be picked up.
the
The recorder changes to microphone input automatically.
2 Insert a recordable MD, and then press and slide REC to the right.
For other operations,“Recordingsee an MD right away!” (page 22).
34