Advanced Operations

Programming

Signals of Another

Remote Control

—Learning function

To operate non-preset A/V components or button functions, use the following “learning” procedure to “programme” any of the programmable signals on the Remote Commander’s buttons.

You can also use the Learning function to change the signal of individual buttons after setting the preset code (page 7). You may find it useful to change the label (page 15) of the learned button.

Note

Some specific remote control signals may not be learned.

1Place the Remote Commander head to head with your A/V component’s remote control.

Other remote control

about 2-4 inches

(5-10 cm) away

RM-VL1400T

2While pressing the(light) button, press the OTHER button.

4Press the COMPONENT select button or Label select button corresponding to the A/V component you want the

Remote Commander to learn.

The selected A/V component’s label appears in the second line on the screen.

5Press the button on which you want to programme the signal.

The display turns off and the Remote Commander enters into the learning mode.

Tip

If you press and hold the button for over 2 seconds, you can change the label. For details, see “Changing the characters on the screen” (page 15).

6Press and hold the button on the other remote control until you hear a beep.

“SET MODE” appears as the screen title.

A beep sounds and the learned button name and “OK” appear in the third line on the screen.

3Press the V/v buttons to select “2 LEARN”, then press the OK button or the centre

Label select button.

“LEARN” appears as the screen title.

Tip

If a number is displayed before the menu, you can select the menu by pressing the number button.

7To programme signals on other buttons, repeat steps 5 and 6.

8Press the(light) button.

The display returns to the screen shown in step 3.

9Press the(light) button or the RETURN button twice.

The set mode closes, and the Remote Commander returns to standby for operating the A/V components.

12GB