If the Remote Commander does not seem to be working properly
If the learned button does not operate properly, clear the learned signal first (page 14), then perform the learning procedure from step 1 again. (For example, if the volume becomes very loud after pressing the 2 (volume) + button just once, noise may have interfered during the learning procedure.)
For accurate learning•Do not move the remote units during the learning procedure.
•Be sure to press and hold the button of the other remote control until you hear the confirmation beep.
•Use fresh batteries in both remote control units.
•Avoid learning in places under direct sunlight or strong fluorescent light, or near a plasma display. (It may cause noise interference.)
•The remote control signal direction may differ depending on the remote control. If Learning does not work, try changing the position of the remote control.
•When you programme the Remote Commander from a remote control unit with an interactive signal exchange system (supplied with some Sony receivers and amplifiers), the response signal of the component may interfere with the Learning of the Remote Commander. In such a case, move to another room, etc., where signals will not interfere.
IMPORTANTBe sure to place the Remote Commander out of the reach of small children or pets.
Also, set the Hold function to lock all the buttons on the Remote Commander (page
11)when it is not used. Devices such as air conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused.
Changing or clearing the function of a “learned” signal
To change the “learned” function, clear it first and perform the learning procedure again.
1While pressing the
(light) button, press the OTHER button.
“SET MODE” appears as the screen title.
2Press the V/v buttons to select “2 LEARN”, then press the OK button or the centre
Label select button.
“LEARN” appears as the screen title.
Tip
If a number is displayed before the menu, you can select the menu by pressing the number button.
3Press the COMPONENT select button or Label select button you want to clear the
learned signal from.
The selected A/V component’s label appears in the second line on the screen.
4While pressing the button on the Remote Commander you want to clear the learned signal from, press the
(light) button.
A beep sounds and the cleared button name and “OK” appear on the screen.
Tip
If you press again the button which you cleared the learned signal from while
pressing the (light) button, the label of the button function and name will be initialized.