Sony snt-v manual HSR-1/1P/2/2P Settings, Video Network Station Settings, Alarm Input Settings

HSR-1/1P/2/2P Settings

On the “Administration overview” page, select the “HSR” icon first, and then the “Setup” icon to make settings on the Setup Menu page. Items not mentioned below should be set according to the operating environment.

Alarm Input Settings

Refer to the HSR-1/1P/2/2P Users Guide for details of HSR-1/1P/2/2P alarm input settings.

Alarm Output Setting

Setting			Value
REMORT	PARALLEL	OUT 1 (pin 15)	ALARM
CONTROL	OUTPUT
	PARALLEL	OUT 1 (pin 15)	12 V
	OUTPUT VOLTAGE

Monitor Display Switching Setting

Setting			Value
IMAGE CONTROL	A IMAGE	ALARM CHANGE	ON

Video Network Station Settings

On the “Administration overview” page, select [Application] with the “Layout and Application Wizard” (page 13), and set the following items. Items not mentioned below should be set according to the operating environment.

Setting		Value	Description
Alarm pop-up window		Disable	When set to [Enable], two
			items, an alarm
			notification window and
			HSR-1/1P/2/2P identifier,
			are displayed.
Switch image when		Disable	Because the HSR-1/1P/2/
Alarm ON			2P switches the image
			when an alarm occurs,
			this does not need to be
			[Enable].
Input 1	Alarm	On	When a number is
	Enabled		entered for the [Number
			of Pre-Alarm Images],
	Alarm On at:	On
			images displayed
	Positive edge
			immediately prior to an
	Alarm On at:	Off
			alarm event at the A
	Negative edge		terminal of the HSR-1/1P/
	Number of	0	2/2P are saved to the
	pre-alarm		alarm memory of the
	images		video network station.
			Therefore, if an image
			from another video
			camera is displayed
			immediately before an
			alarm, the required image
			is not recorded.

zHint

•To ensure recording of images before an alarm event, on the “Administration overview” page, select the [HSR] icon first, and then the [Setup] icon and set the “RECORDING MODE” to [PRE-ALARM] on the “RECORDING FUNCTION” page. In this case, image confirmation is performed at the HSR-1/1P/2/ 2P “ALARM SEARCH”. Refer to the HSR-1/1P/2/ 2P Users Guide for details of HSR-1/1P/2/2P alarm recording.

•When four video cameras are connected to HSR-1/ 1P/2/2P video input terminals 1 to 4 and the HSR View is set to display four partitions, if an alarm event occurs at any camera, the number of images set for the [Number of PRE-Alarm Images] is saved. However, in this case, the saved image will consist of the four displayed partitions.

39