qf OUTPUT fader
You can adjust the OUTPUT fader by dragging the fader portion.
The yellow marker displayed on the side of the fader indicates the fader position that is the addition of the OUTPUT fader setup. When the sound volume of a specific input channel is to be set from the REMOTE screen and the GROUP FADER screen, the fader position determined by the
(The fader level at the yellow marker position in Fig. 2 is the
Signal flow
+10 | +10 |
+5 | +5 |
ROUTING 0 |
| 0 | 0 | OUTPUT |
|
|
| ||
+10 |
| |||
MASTER volume |
| |||
of the |
|
REMOTE1 to 6 | OUTPUT fader |
of the GROUP | on the OUTPUT |
FADER screen | OVERVIEW |
| screen |
| Fig. 2 |
qg REC OUT index
Displays the index that is entered on the BLOCK screen.
qh REC OUT level meter
Displays the output signal level using the VU response.
qj REC OUT REF LEVEL selection box
You can set the reference output level for every output channel on this selection box.
You can select
qk REC OUT MUTING button
Mutes output signals of the respective channels. The REC OUT MUTING button lights in red when muted.
Power Amplifier Block
ql Operation mode setup box
Selects one of the following modes depending on the type of speaker to be connected.
Lo Imp.: A low impedance (4 Ω to 16 Ω) speaker is to be connected.
70 V LINE: A high impedance (32 Ω to 10 kΩ) speaker is to be connected.
In the case of 70 V LINE, the channel 1 setup becomes valid for the selectors and attenuators.
w; PROTECTION indicator
The PROTECTION indicator lights in red when the internal power amplifier protection circuit operates.
Note
When the PROTECTION indicator lights
The protection circuit operates (PROTECTION indicator lights) and the speaker and amplifier are protected from damage by decreasing or cutting the output signal in case of the following:
•If the temperature of the heat sink inside the amplifier exceeds the specified value.
The connected speaker impedance is too low.
Air intake and air exhaust holes (on the right and left sides of the
•The SPEAKER terminal is
In such a case, turn the POWER switch to the OFF position and remove the cause of the fault before using the unit again.
•If DC voltage appears in the SPEAKER terminal due to failure. Turn off the POWER switch and contact your Sony representative where you purchased the unit or contact your local Sony Sales office or Dealer.
wa SPEAKER OUTPUT index
Displays the index that is entered on the BLOCK screen.
ws SELECT setup box
Selects the input signal to the internal power amplifier. When the 70V LINE is selected, the channel 1 setup only is valid.
wd ATT
Adjusts the output level for the internal power amplifier. Clicking the [+] or
10 dB position for ordinary use.
wf SPEAKER OUTPUT MUTING button
Mutes the speaker output. The SPEAKER OUTPUT MUTING button lights in red when muted. When the 70V LINE is selected, the channel 1 only can be operated.
wg CLIP indicator
The CLIP indicator lights in red when the internal power amplifier clips. Adjust the output level using wd ATT so that the CLIP indicator does not light frequently.
17