Sony SRP-X700P Connection to projector, How to set the communication protocol, 1.Port setup, 2.PROJECTOR POWER ON setup, 3.PROJECTOR POWER STANDBY setup, Setting example

Names and Functions of Controls on Screen

Connection to projector

For details of the method of connecting to a projector, see “System example when operating the SRP-X700P with the default setting when shipped from the factory” of the SRP-X700P Operating Instructions.

When the RGB signal distributor to be connected to the projector, connect them as shown below.

		SRP-X700P				Projector
						S VIDEO
						VIDEO
	S VIDEO	VIDEO				RGB
	R/R-Y	G/Y B/B-Y	SYNC/HD	VD
					RGB	COMPONENT
					distributor
1	OUTPUT	CONTROL-S
	3	IN	RS-232C			RS-232C
2	4	OUT

How to set the communication protocol

Set the communication protocol as follows.

1.Port setup

Set the BITS PER SECOND setup box and the PARITY BIT setup box in accordance with the specifications of the projector.

2.PROJECTOR POWER ON setup

1Enter the PROJECTOR POWER ON command of the projector, in the COMMAND setup box in which the

PROJECTOR POWER ON setup should be entered.

2Set 60 seconds in the WAIT setup box. This will be finally adjusted during the operation check.

Note

If the commands that can be received by the projector are specified as ASCII code, convert the ASCII code to a hexadecimal number and enter it in the COMMAND setup box.

3.PROJECTOR POWER STANDBY setup

1Enter the PROJECTOR POWER STANDBY command of the projector, in the COMMAND setup box in which the

PROJECTOR POWER STANDBY setup should be entered.

2Set 100 seconds in the WAIT setup box. This will be finally adjusted during the operation check.

4.INPUT SELECT command setup

1 Select the respective signal formats using the signal format select button and enter the command in the COMMAND setup box as shown below.

•When the projector input can be selected by sending a single command only, enter the INPUT SELECT command in COMMAND1 and leave COMMAND2 unset (blank).

•When the two commands of both the signal system select command and the input terminal select command are required to select the input to the projector, enter the signal system select command in COMMAND1 and enter the input terminal select command in COMMAND2.

Setting example

When the signal systems of VIDEO, S VIDEO, COMPONENT and RGB are used, and when a single command is required for the VIDEO and S VIDEO input selection while both commands are required for the COMPONENT and RGB input signal selection, set as shown below.

Signal system	COMMAND1	COMMAND2
VIDEO	VIDEO input terminal	Unset (blank)
	select command
	S VIDEO input
S VIDEO	terminal select	Unset (blank)
	command
	COMPONENT signal	COMPONENT/RGB
COMPONENT		input terminal select
	select command	command
	RGB signal select	COMPONENT/RGB
RGB		input terminal select
	command
		command
LAN	Unset (blank)	Unset (blank)

2Set WAIT1 to 1 second and set WAIT2 to 9 seconds in the WAIT setup box. This will be finally adjusted during the operation check.

26