Names and Functions of Controls on Screen
INPUT SELECT command setup
Sets the command to select the input terminal of the projector in accordance with the
The
By this system, the
The INPUT SELECT command is set for the respective signal systems. A maximum of two commands can be set for a single signal system.
qs
qd
qs Signal system select button
Selects the video signal format to which the INPUT SELECT command will be set.
qd COMMAND setup box
Sets the command to be sent from the
Enter the command as a hexadecimal number using numbers 0 to 9 and letters A to F.
The maximum length of the command is 24 bytes.
When a projector model that allows the input to be selected by a single command is used, set the command in the COMMAND setup box1 only.
Some projector models that support multiple video signal formats with a single input channel, require two commands, the video signal format select command and the input terminal select command, in order to select the input.
For such projector models, set the video signal format select command in the COMMAND setup box1 and set the input terminal select command in the COMMAND setup box2. The two commands will be sent from the
qg
qf
qh
qf WAIT setup box
Some projector models do not accept commands for several seconds after the projector input signal has been switched while the input selection is being executed.
Therefore, the wait time before sending the next command after COMMAND1 has been sent from the
The wait time can be set in the range of 1 to 20 seconds in 1- second steps.
The same setting applies to all signal systems.
qg TEST button
Tests the INPUT SELECT command.
qh Command sequence
The sequence of the
24