Names and Functions of Controls on Screen

PROJECTOR CONTROL Block

You can establish various setups to control a projector, refer to “How to Control the Display from the SRP-X700P” of the SRP- X700P Operating Instruction.

q; I/F TYPE

The connection method that corresponds to the projector selected by qa PROJECTOR PROTOCOL setup box, is displayed.

qa PROJECTOR PROTOCOL setup box

Selects a projector that is to be connected to the PROJECTOR CONTROL terminal.

When USER DEFINE is selected, the projector is controlled by the communication protocol set on the USER DEFINE screen.

Once the communication protocol for the projector has been set on the USER DEFINE screen, the projectors not supported by default can be connected.

When USER DEFINE is selected, 0 I/F TYPE is set in RS- 232C.

zWhen USER DEFINE is selected and qf USER DEFINE button is clicked, the communication protocol with projector can be set.

qs REMOTE POWER ENABLE button

You can interlock the power on/off control of the projector with the POWER button of the SRP-X700P. The REMOTE POWER ENABLE button lights in green when interlocked.

qd SIGNAL DEFINE setup box

Select the video signal format for each channel of the LINE 4 input, that is sent to projector.

•LINE4A to LINE4C: You can select VIDEO, S VIDEO or LAN.

•LINE4D to LINE4F: You can select RGB, COMPONENT or LAN.

When you select LAN, the LAN input connector of a projector is automatically selected.

Note

•When you connect a projector with the Control S, you cannot mix the RGB signal with the COMPONENT signal.

•When you select LAN, select an appropriate projector supporting LAN.

qf USER DEFINE button

Shows the USER DEFINE screen in the PROJECTOR PROTOCOL setup box, to set the communication protocol used when USER DEFINE is selected.

When index is set in the USER DEFINE screen, the index is displayed on the button.

Note

If USER DEFINE is not selected in the PROJECTOR PROTOCOL setup box, clicking is disabled.

Setting Parameters of PARALLEL I/O

Procedure for setting FUNCTION on the REMOTE screen

Example: The procedure for setting the LINE4 input to “A” when PARALLEL INPUT 1 is set to ON:

<Setting FUNCTION>

<Setting parameter>

Click the PARALLEL

Completed.

 

INPUT FUNCTION

Click the dropdown list

setup box.

to display parameters.

Select the desired

Select a parameter.

FUNCTION.

 

* For the contents of each item, perform the same step referring to the table shown on page 21.

20