Port setup

Sets the communication conditions between the SRP-X700P and projectors.

4

4BITS PER SECOND setup box

Sets the baud rate.

Select the desired speed to 9600, 19200, or 38400 bps depending on the baud rate of the projector.

5

5PARITY BIT setup box

Sets the parity bit.

Select NONE, ODD, or EVEN depending on the communication data specifications of the projector.

PROJECTOR POWER ON setup

Sets the command to turn on the projector power and sets the wait time after the command has been sent.

7

68

6 COMMAND setup box

7 WAIT setup box

Sets the command to be sent from the SRP-X700P to the projector to turn on the projector power.

Enter the command as a hexadecimal number using numbers 0 to 9 and letters A to F.

The maximum length of the command is 24 bytes.

The projector stops receiving any command after the power on until its operation has stabilized.

Therefore, enter the wait time before sending the next command after the power-on command has been sent from the SRP-X700P to the projector.

The wait time can be set in the range of 10 to 200 seconds in 10-second steps.

8 TEST button

Tests the PROJECTOR POWER ON command.

PROJECTOR POWER STANDBY setup

Sets the command to put the projector in the power standby state and sets the wait time after the command has been sent.

 

0

9

qa

9 COMMAND setup box

q; WAIT setup box

Sets the command to be sent from the SRP-X700P to the projector to put the projector in the power standby state.

Enter the command as a hexadecimal number using numbers 0 to 9 and letters A to F.

The maximum length of the command is 24 bytes.

The projector stops receiving any command after it has entered the power standby state until the standby operation is complete.

Therefore, enter the wait time before sending the next command after the power-standby command has been sent from the SRP-X700P to the projector.

The wait time can be set in the range of 10 to 200 seconds in 10-second steps.

qa TEST button

Tests the PROJECTOR POWER STANDBY command.

23