Automatic Tuning
For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 38.
1Press TUNER to light the button up.
The last received station is tuned in.
2Press FM/AM to select the FM or AM band.
3Press TUNING + or TUNING
Press the + button to scan from low to high; press the – button to scan from high to low.
When the receiver reaches either end of the band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is received.
4To continue scanning, press TUNING + or TUNING – again.
Preset Tuning
For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 38.
Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations” below.
Presetting radio stations
1Press TUNER to light the button up.
The last received station is tuned in.
2Tune in the station that you want to preset using Direct Tuning (page 38)‚ or Automatic Tuning (this page).
3Press MEMORY.
“MEMORY” appears in the display for a few seconds. Do Steps 4 to 6 before “MEMORY” goes out.
4Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter “A”, “B” or “C” appears in the display.
5Select a preset number by pressing it (0 to 9).
If “MEMORY” goes out before you press the preset number, start again from Step 3.
6Press MEMORY again to store the station.
If “MEMORY” goes out before you press the preset number, start again from Step 3.
7Repeat Steps 2 to 6 to preset another station.
To change a preset number to another station
Do Steps 1 to 6 to preset the new station to the number.
Note
If the AC power cord is disconnected for about one week, all the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.
Broadcasts Receiving