Sony UP-2100, UP-2100SD Making Connections for Viewing Images to be Printed, Connections (continued), To set the printer output to THRU

Connections (continued)

Making Connections for Viewing Images to be Printed

Connect a video monitor to view stored images and to check those to be printed. Connect the necessary video monitor which will be used in actual printing, using the following diagram as a guide.

	INPUT	OUTPUT
REMOTE	S-VIDEO	VIDEO S-VIDEO VIDEO

1 2

~ AC IN

to S-VIDEO OUTPUT

UP-2100/2100SD

	Connecting cable (with
	DIN 4-pin connectors)
Video monitor	YC-15EV
	to S-VIDEO
	input connector
	to composite video
	input connector

to VIDEO OUTPUT

to AC IN

75-ohm coaxial cable with BNC connectors

AC power cord (supplied)

to wall outlet

pWhen the video monitor color does not match to that of a printout

It is difficult to image printout results because the video monitor color does not match to that of a printout. In such a case, the video monitor color may not be adjusted correctly even if the printer color is correctly adjusted. Check the color adjustment of the video monitor.

The printer outputs either of the following two kinds of video signals according to the printer setting described below.

•EE (E to E): Signals are output to the monitor after being processed by the printer‘s circuitry.

•THRU (THROUGH): Signals are output to the printer as is.

Use the THROUGH signal to check the video monitor.

When you select THRU, the signal flow inside the printer is as follows.

— Signal input to the VIDEO IN connector	nOutputs to the VIDEO OUT
connector.	nOutputs to the S VIDEO OUT
— Signal input to the S VIDEO IN connector
connector.

To set the printer output to THRU

1Press the MENU button, then display the OUTPUT SETUP menu by pressing the ıor ￿button.

2Select SOURCE by pressing the ￿or ￿ button.

3Select THRU by pressing the ıor ￿button.

For details of how to make adjustments using menus, see “Setting Up the Printer” on page 56.

54Installation and Adjustment