Sony UP-2100, UP-2100SD Warning messages, Error/Warning Messages (continued)

Error/Warning Messages (continued)

Message Possible cause and remedies

INSERT RIBBON AND PAPER The ink ribbon cartridge and paper are not loaded.

nLoad the ink ribbon cartridge and paper. (pages 8 and 11)

REMOVE PRINTS	The maximum number of printouts has accumulated on the paper cover.
	nRemove the printouts from the paper cover. (page 79)
REMOVE PAPER: TRAY	The paper jams around the paper tray as it is being fed into the ribbon area.
	nRemove any jammed paper. (page 79)

Warning messages

	In the case of a warning, only warning messages appear. The ALARM lamp does
	not light.
Warning message	Possible causes and remedies
PLEASE WAIT	The printer is printing, preventing any other operation.
NOW PRINTING	nWait until the printer finishes printing, then retry the operation.
HIT ANY KEY	This message appears when the remote control unit is used in CAPTURE STOP mode and when the
	printer stops capturing images to memory pages once images have been captured to all memory pages.
	nPress any button. Printer operation is enabled after this.
INPUT MISMATCH	•The TV system of the signal input from the source equipment (VTR, video camera and so on) is not
	compatible with the TV system of your printer.
	nCheck the signal of TV system and input the correct one.
	•The signal other than the video signal (such as audio signal and similar) is input.
	nInput the correct video signal.
PLEASE WAIT	Printing is queued for the selected memory page.
RESERVED MEMORY	nRetry the operation once the printer finishes printing.
PLEASE WAIT	The image captured in the selected memory page is being printed.
PRINTING MEMORY	nRetry the operation once the printer finishes printing.
NO INPUT	The printer is not receiving an input signal from equipment corresponding to the input selected on the
	INPUT SETUP menu.
	nCheck the input signal selected on the INPUT SETUP menu. (page 13)
	nCheck whether the video equipment is outputting a video signal in playback mode.
	nCheck that the connections between signal source equipment and the printer are secure. (page 65)
NO IMAGE	The image is not captured in memory.
	nCapture the image in memory then start printing. (page 15)
PLEASE WAIT	The thermal head has overheated.
HEAD IN COOLING	nLeave the printer until the head cools down and this message disappears. The printer starts printing
	automatically.
PLEASE WAIT	The inside of the printer has overheated.
SET IN COOLING	nLeave the printer until its inside cools down and this message disappears. The printer starts printing
	automatically.

78Others