Sony UP-2100, UP-2100SD Specifications (continued), When IMMED. CAP. is set to ON, When IMMED. CAP. is set to OFF, Remote 2 connector pin assignment

Specifications (continued)

Using the automatic printing capabilities (REMOTE 2)

If you send the remote control pulse signals illustrated through the REMOTE 2 connector, the printer is remotely controlled according to the remote control setting. (see page 65)

Turn on the power of the printer and display the source image on the monitor screen. Send a remote control pulse signal at the timing shown below. The timing depends on the setting on item IMMED. CAP of the FUNCTION SETUP menu.

Remote 2 connector pin assignment

GND

BUSY

MIN

FL2FL1

CN5

1

2

3

Note

The remote control pulse signal examples introduced here are one of the typical operation timing. The timing may be affected due to the selected memory page and print type.

When IMMED. CAP. is set to OFF

	V-SYNC	0	1	5	6	7	8	9
Remote
control	MIN		tRPE		tRPW	Captured image
pulse
	(IN)							VRP
signal
	BUSY
	(OUT)

Notation Parameter		MIN	TYP	MAX Unit		Remarks
tRPE	Time within which 3		—	12	msec —
	a remote control
	pulse should be
	cleared to zero.
tRPW	Length of a	100	—	—	msec —
	remote control
	pulse.
VRP	Amplitude of a	—	—	5	V	This value
	remote control					is based
	pulse.					on TTL
						standards.

Note

When AUTO LIVE of the FUNCTION-SETUP menu is set to OFF, the memory image is displayed on the screen after the image is captured in memory. In such a case, whenever you store the image, press the SOURCE/MEMORY button so that the source image appears on the video monitor. Displaying the memory image does not allow to capture the image with the correct timing.

When IMMED. CAP. is set to ON

	V-SYNC		0	1		2		3		8
Remote
					Captured image
control
pulse										vRP
signal				tRPE			tRPW
Notation Parameter					MIN	TYP		MAX	Unit	Remarks
tRPE		Time within which 3				—		10	msec —
		a remote control
		pulse should be
		cleared to zero.
tRPW		Length of a		100		—		—	msec —
		remote control
		pulse.
VRP		Amplitude of a			—	—		5	V	This value
		remote control								is based
		pulse.								on TTL
										standards.

Note

This mode is effective only the source image is displayed on the monitor screen. If the memory image is displayed, the image will not be captured even if the pulse is sent to the printer. Be sure to display the source image when sending the pulse.

Design and specifications are subject to change without notice.

76Others