Installation
Connecting the Power Cord
Connect the supplied power cord to the ~ AC IN connector on the back of the unit, and then connect the plug to a power outlet.
Preparations 2 Chapter
Power cord (supplied)
Power outlet
Loading Paper Roll and Ribbon Cartridge
Handling the paper roll and ribbon cartridge
Notes
•The print pack contains two ribbon cartridges and two paper rolls. Be sure to use the ribbon cartridge and paper roll in the same carton as a set. (See “Ribbon Cartridge and Paper” on page 55.)
•The number of sheets that can be printed depends on the print pack type. The table below lists the image count for one ribbon cartridge and paper roll set.
Print pack | |||
Number of | 300 (sheets) | 200 (sheets) | 172 (sheets) |
sheets |
|
|
|
|
|
|
|
Print size | 3.5 × 5 inches | 4 × 6 inches | 5 × 7 inches |
| (89 × 127 | (102 × 152 | (127 × 178 |
| mm) | mm) | mm) |
|
|
|
|
•Do not replace the ribbon cartridge and paper roll before they are used up. Otherwise the above number of sheets may not be achieved.
•Place the paper roll vertically. If you place the paper roll horizontally, the paper roll may roll around and fall. This may cause an injury.
Adjusting the Display Angle
The display angle can be adjusted to make the display more easily viewable. Eight settings are available for angle adjustment.
When storing the unit, pull the display forward until completely upright and then push it backward until horizontal.
•Hold the paper roll with both hands so that you do not drop it, because it is heavy. Dropping may result in an injury.
Hold the paper roll with both hands.
10 Installation