
Connection to a Computer
To control the unit from a computer, you must connect the unit to the computer using a commercially available USB cable. Plug the USB cable into the USB port (device) on the rear of the unit.
When making the connection, you should also consult the documentation of the computer.
Operation 4 Chapter
USB cable
Computer
Note
If the connection is made via a USB hub, correct operation is not assured.
Attaching a ferrite core to a USB cable
Before connecting a USB cable (not supplied) to the printer, you should attach a supplied ferrite core to its cable for noise prevention. To conform to radiation standards, attach the supplied ferrite core to the USB cable of your device as described below.
1 Release two stoppers on the ferrite core to open it.
2 Slip the USB cable through the ferrite core and position it at the base of the USB connector to the printer.
3 Close the ferrite core until you hear a click.
Note
When the ferrite core cannot be secure because the USB cable is thin, secure it using a tape.
48 Printing From a Computer