Sony UP-21MD, UP20 Connections, Connecting Video Equipment

Preparation

Connections

To enable printing, video equipment to act as an input signal source, and a video monitor to display images or menus must be connected.

The following diagrams illustrate how to make the input, output and remote control connections. Use this as a guide when connecting the cables required to transmit signals to and from the equipment to be used for printing.

Notes

•Turn off the power of each device before attempting to make any connections.

•Connect the AC power cord last.

Connecting Video Equipment

Connect the video equipment providing the video images to be printed.

Connect the video equipment which will be used in actual printing, using the following diagram as a guide. Before connecting the video equipment, see “Important safeguards/notices for use in the medical environments” on page 2.

	Video equipment
to RGB	to composite
output	video output
connectors	connector

	to S VIDEO					75-ohm
75-ohm
			output
coaxial cable						coaxial cable
		connector
with BNC						with BNC
connectors						connectors
						Connecting
						cable (with
				to S		DIN 4-pin
						connectors)
			VIDEO
to RGB SYNC b)
			INPUT
INPUT
					to VIDEO
					INPUT
UP-21MD

to AC IN

NTSC/PAL selector a)

AC power cord (supplied)

to wall outlet

a)Set the NTSC/PAL selector to match your TV system. To switch the TV system, turn the power off once, then change the setting. If you change the setting with the power on, this mode will not be switched.

b)Only for the UP-21MD.

10 Connections