Introduction

JDISPLAY button (19, 36)

When the regular screen is displayed, pressing this button toggles the screen display of messages such as Q1, A, etc., on and off regardless of the setting of the DISPLAY item in the OUTPUT SETUP menu. The setting of DISPLAY in the OUTPUT SETUP menu changes linked with the press of this button. When the menu is displayed, pressing this button temporarily clears the menu display. While this button is held down, the menu display disappears.

KCursor keys

Use to select a desired item from the menu. Also, these keys are used to position the cursor (green pointer) on the regular screen when capturing multiple reduced images.

LCLEAR button (35, 36)

Press this button to clear the images captured in the memory pages. Which images can be cleared with the CLEAR button depends on the setting made with the FUNCTION SETUP menu.

When the clear function of this button is set to OFF, the buzzer sounds if you press the CLEAR button.

MEXEC button

Press this button to execute the values set with the COLOR ADJUST menu or to load a user set in the PRINTER SETUP menu and to register the user set in the SYSTEM SETUP menu. Also, this button is used to enter the characters of a caption in the CAPTION menu.

N PRINT button

Press this button to make a printout.

O CAPTURE button

Press this button to capture an image in a memory page.

P SOURCE/MEMORY button

Press this button to select which signal is to be output to the monitor.

The memory image and source image are toggled each time you press this button.

QPaper output slot

Printed pages (printouts) are ejected here. Depending on the curled condition of printouts, the printer may stop printing and display the message “REMOVE PRINTS.” In such a case, remove the printouts accumulated on the paper tray. The printer will start to print the remaining copies automatically. When the UPC-21L printing pack is used, the ejected printouts are accumulated on the paper tray, but protruding from the tray. Do not

block this output slot. Doing so may cause the paper to jam.

RPaper tray (9, 15)

Load paper into this tray.

S! POWER switch

Press this switch to turn the printer on or off.

Rear Panel

UP-21MD

UP-20

6 Location and Function of Parts and Controls