PowerPowerSupplySupply

This section explains the power supply for each component.

•Half-rack size diversity tuner (URX-R1)

Connect the supplied AC adapter to the DC IN 9V connector on the rear panel, and then connect the AC adapter to a wall outlet.

•Diversity tuner module (URX-M1)

When incorporated into another component (e.g., MB-806A, SRP- X700P, etc.), the tuner module draws its power from that component.

For details on the power supply to the diversity tuner module, refer to the operating instructions of the component in which the diversity tuner module is installed.

•Body-pack transmitter (UTX- B1), hand-held microphone (UTX-H1), plug-on transmitter (UTX-P1), and portable diversity tuner (URX-P1)

These components can be powered by two LR6 (size AA) alkaline batteries for about six hours of continuous operation (at 25 ºC (77ºF)). Details on inserting the batteries and the battery condition indication are given below:

Inserting the batteries

Body-pack transmitter (UTX- B1)/portable diversity tuner (URX-P1)

The procedure below uses the body- pack transmitter (UTX-B1) in the illustrations. Batteries are, however, inserted in the portable diversity tuner (URX-P1) in the same manner.

1 Slide the latches on both sides of the transmitter/tuner at the same time and open the battery compartment.

Latch

2 Align two new LR6 (size AA) alkaline batteries with the polarity markings and insert them into the battery compartment, and then close the cover.

38