Settings

Setting the

transmission channel

The procedure below is the same for all UWP series transmitters (UTX-B1/H1/P1).

Refer to the pdf files “Sony Wireless Microphone System Frequency List” on the supplied CD-ROM for details on the selectable channel groups and channels (for U62, U66, CE62, and CE67 models) or the supplied leaflet “Sony Wireless Microphone System Frequency List” (for AU66 and CE67 models).

1 Turn on the transmitter while pressing down the SET button.

Keep pressing the SET button until the display section parameters that were displayed when the unit was last turned off start to flash.

2 Press the SET button repeatedly until the channel number (or frequency) indication appears.

3 Press the + or – button to select the channel number (or frequency).

Pressing the + button cycles the indication in the order shown in the tables in the pdf files “Sony Wireless Microphone System Frequency List” on the supplied CD-ROM (for U62, U66, CE62, and CE67 models) or the supplied leaflet “Sony Wireless

Microphone System Frequency List” (for AU66 and CE67 models).

Pressing the – button cycles the indications in the opposite direction.

Hold down the + or – button to change the channel number (or frequency) faster.

Notes on the European model

Select the group number before selecting the channel number as follows.

1)While the left two digits are flashing, select the group number by pressing the + or – button.

2)When the desired group number appears, press the SET button.

The right four digits start to flash to allow the selection of the channel number.

3)Select the channel number by pressing the + or – button.

Group Channel Frequency selection selection selection

V : + button v : – button

Group, channel, and frequency selection examples for CE62 model are shown.

47