Settings
•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.
•If you turn off the tuner and then immediately turn it on right after setting the reception channel, the unit may not operate normally. Wait a few seconds before turning it on again.
Detecting and selecting the available channels automatically (diversity tuner module
When multiple diversity tuner modules
1 Turn off all the microphones and transmitters.
2 Select the channel group on the tuner module installed into the slot 1 of the
3 After confirming that the channel group indication has stopped flashing (about 10 seconds after you have selected the channel group), keep pressing the + button on the tuner module installed into the slot 1 of the
50
All the tuner modules installed into the
After the automatic detection and selection of available channels finish, you can change the group and channel on each tuner module manually.
Notes
•Do the automatic detection and selection of available channels with the channel group other than channel group 00.
•When there are unavailable channels due to extraneous radio wave and the channel could not be selected on some tuner modules, “NO CH” appears on the display of those tuner modules. If this happens, select the channel group with no interference from extraneous radio wave, and repeat the procedure above.
Setting the attenuation
level of the audio input
The procedure below is the same for all UWP series transmitters
The attenuation level can be set during signal transmission.
1 Do the following while there is no signal transmission. Turn on the transmitter while pressing down the SET button, and press the SET button repeatedly until the attenuation level indication appears in the display section.