Settings
4 When the desired channel number (or frequency) appears, set the POWER switch to OFF to complete the setting, or press the SET button to set other items.
The results are stored in memory. The stored channel number (or frequency) will appear in the display section the next time you turn on the transmitter by setting the POWER switch to ON.
N o t e s
•When you are setting the transmission channel, the transmitter cannot be used to transmit signals.
•Do not remove the batteries while setting the transmission channel. If they are inadvertently removed, re- insert them immediately and redo the procedure “Setting the transmission channel” from step 1.
•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.
•If you turn off the transmitter and then immediately turn it on right after setting the transmission channel, the unit may not operate normally. Wait a few seconds before turning it on again.
Setting the reception
channel
The procedure below is the same for all UWP series tuners
Refer to the pdf files “Sony Wireless Microphone System Frequency List” on the supplied
1 Press down the SET button for more than one second.
Keep pressing the SET button until the display section parameters start to flash.
2 Press the SET button repeatedly until the channel group and the channel number indications appear.
The channel group indication starts to flash.
3 Press the + or – button to select the channel group.
Pressing the + button cycles the indication in the order shown in the tables in the pdf files “Sony Wireless Microphone System Frequency List” on the supplied
48