Troubleshooting
Symptom | Meanings/Remedy | |
|
|
|
There is distortion in the sound. | The attenuation level of the transmitter is too low. b | |
|
| The input level of the tuner is extremely high. Press |
|
| the – button on the transmitter in attenuation level |
|
| setting mode to raise the attenuation level. |
|
|
|
|
| The transmitter and the tuner are set to different |
|
| channels. b Set the transmitter to the same channel. |
|
| |
There is sound interruption or | The RF indications on the tuner appear (the RF | |
noise. | indicator lights up) even when the transmitter is off. b | |
|
| Jamming radio waves are being received. Determine |
|
| which channels are usable (i.e., channels for which |
|
| the RF indications on the tuner do not appear (or for |
|
| which the RF indicator on the tuner does not light up) |
|
| and set the tuner and transmitter to the same usable |
|
| channel. When two or more transmitters are used |
|
| simultaneously, use another channel group that is |
|
| unaffected by jamming radio waves. |
|
|
|
|
| The transmitter and the tuner are set to different |
|
| channels. b Set the transmitter to the same channel. |
|
|
|
|
| Two or more transmitters are set to the same channel. |
|
| b Set each transmitter to a different channel. |
|
|
|
|
| The transmitters are not set to the channels within the |
|
| same channel group. b The channel plan which the |
|
| UWP series components use is set so that no signal |
|
| interference occurs when 2 or more transmitters are |
|
| used simultaneously. Set each transmitter to a |
|
| different channel within the same channel group. |
|
|
|
60