OSD MENU 4
Pattern Setup
PATTERN SETUP
PATTERN NO. 1 UNDEFINED
CLR PATTERN CANCEL RUN PATTERN
<EDIT PATTERN>
BACK
EXIT
Pattern Edit
EDIT PATTERN 1
MOVE TO START POSITION [NEAR:START /FAR:CANCEL]
zPattern Number [1~4 ]
Selects a Pattern number to edit. If the
selected pattern number is not defined, "UNDEFINED" will be displayed under the selected pattern number.
zClear Pattern [CANCEL/OK]
| Deletes the data of the selected pattern. |
zRun Pattern | Runs the Pattern for the test purposes to |
| check if it works properly. |
z Edit Pattern | Edits the selected pattern. |
①With the Joystick of your controller, move the camera to the start position with an appropriate zoom magnafication. To start the pattern recording, press NEAR key. To exit, press FAR key.
EDIT PATTERN 1
[NEAR:SAVE /FAR:DELETE] 0/0/x1/N
②Move camera with joystick of controller or run preset function to memorize the path (mostly curve path) in the selected pattern. The movement by Joystick and preset movement will be memorized in a pattern. After a pattern is programmed, the remaining storage is displayed in progress bar on the screen.
③To save the data and exit, press NEAR key. To cancel saving the data and delete the data, press FAR key.
37X Speed Dome Camera | 40/50 |
