Rev. 0.00
3-141
STARLineModeCommandSpecications
2) Bar code data setting command
This command set the bar code print data.
There are four types of data types that can be set by the QR code. They are: numbers, alpha-numeric characters,
binary and Kanji characters. However, with these specifications, there are two data setting methods. They are: A
method that specifies that data along with the bar code data (data manual analysis); and a method that specifies only
the bar code data (data automatic analysis).
(3) Page mode setting command
This command is not used.
4) Bar code printing command
This command prints the bar codes based on the settings of (1) and (3).
5) Get bar code expansion information command
This command checks whether a bar code can be printed based on the settings of (1) to (3).
= Precautions When Using the Commands =
• For (1) to (3), the setting values are retained if the following operations are not applied.
• New setting command is sent.
•Initializecommandsaresent(<ESC>@,<CAN>)
• Power is turned off.
• With regard to (2), when an error occurs in command transmission, the set data is cleared, and the command is in-
valid.
• With regard to (4) and (5), send as needed.
• Printing
• When printing, the horizontal tabs, absolute position specification, relative position specification, and position move-
ment using position alignment are valid.
• Upside down printing and 2-color printing are possible.
• Bar codes to be printed should always be confirmed through an actual printout.