Rev. 0.00
3-149
STARLineModeCommandSpecications
ESC GS h 1 k m n
[Name] Water mark function
[Code] ASCII ESC GS h 1 k m n
Hexadecimal 1B 1D 68 31 k m n
Decimal 27 29 104 49 k m n
[DenedArea] Thermal : 0 ≤ k ≤ 2, 0 ≤ m ≤ 2, 1 ≤ n ≤ 255
Slip : -
Validation : -
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function]
<Thermal>
Sets to make water mark function valid/invalid.
k Water Mark Function
0 Invalid
1 Valid
Printsonelogospeciedbynatthepositioncenteredinthehorizontalandvertical
directions.
2 Valid
Repeatedlyprintslogospeciedbynfromleadingedgeofthepagetothetrailingendofthe
page, at the position centered in the horizontal direction.
Set the forming method of the logo data to be printed as the water mark to make the image appropri-
ate as the water mark with this setting.
If the appropriate image is not possible with this setting, re-register after forming the logo data regis-
tered as the water mark as the appropriate data.
m Water Mark Data Forming
0Printslogodataspeciednasitis.
1Thinslogodataspeciedn25%intheprintout.
2Thinslogodataspeciedn12.5%intheprintout.
Specify the registered logo as the water mark.
n Logo Number
1 to 255 Registered logo number
Ifthespeciedlogonumberisnotregistered,thewatermarkwillnotbeprinted.
<WaterMarkFunction>
When the water mark inversion function is valid, it is printed by the water mark pinting trigger.
However, this function is executed on print data that fits in the image buffer length.
If print data is larger than the image buffer length, water mark printing is ignored.
Also, when starting printing using anything other than the water mark printing trigger, water mark
printing is ignored.
When in 2-color printing mode, this function is invalid.
This setting is not cleared by the ESC @, CAN commands.
Water Mark Printing Triggers
• Cutter Command : ESC d n
• FF Command : FF
• BM Detection Command : ESC d n, FF
• Print Startup Command : ESC GS g 0 m n
• Raster Mode : When executing FF