Rev. 0.00
3-34
STARLIneModeCommandSpecications
ESC C 0 n
[Name] Set n x 24 mm page length
[Code] ASCII ESC C 0 n
Hexadecimal 1B 43 00 n
Decimal 27 67 0 n
[DenedArea] Thermal : 1 ≤ n ≤ 22
Slip : -
Validation : -
[Initial Value] Thermal : (Form feed amount initial value x 42)
Slip : -
Validation : -
[Function]
<Thermal>
The position whereat this command is processed is considered the top of the page and sets the
page length to (n x 24 mm).
This command cancels the bottom margin setting when setting page length.
The page length set using this command is unaffected by changing the form feed amount later.
Moving to the top of the page is performed using the following commands.
• Form feed command (FF): Execute form feed
• Cutter command (ESC d n): Sets cutter position at top of page.
• Raster command (ESC * r B): Top of page when raster mode ends.
• Error cancel operations: Sets error cancel operation end position at the top of the page.
<Slip>,<Validation>
Only setting is valid
Setting is valid after switching to thermal.