If the paper park facility does not appear to be working correctly, check the following:
Check
Is the paper release lever in the C position?
Has the fanfold paper been properly parked?
Possible remedy
The paper release lever must be set to the C position after the fanfold paper has been parked.
Make sure that the POWER indicator comes on flashing after the fanfold paper has been parked.
If text is being printed all on one line, or with extra blank lines, check the following:
Check
Is the text all on the same line?
Is text being printed with extra blank lines?
Possible remedy
Carriage returns are not being expanded to <CR> + <LF> pairs. Check the DIP switch setting and correct.
Two line feeds are being printed. Either make your software print just a carriage return or (if this is not possible), set the AUTO LF to OFF with the DIP switch setting.
If the page length and margins are not what is expected, check the following:
Check
Is the printing starting too high or too low on the page?
Does the printer’s page length not match the physical page length?
Possible remedy
Use the Micro Feed facility to adjust the print position relative to the page.
Use the DIP switch to set up the correct page length, or use software commands to do it.
