Federal Communications Commission
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part IS of FCC Rules. These limits are designed to provide reasonable protection against harmful Interference m a residential installation. This equipment generates, uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installanon. If thta equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or reloate the receiving antenna.
*Increase the separation between the equipment and receiver.
*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
*Consult the dealer or an experienced radio/TV technician for help.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
The uhm~e .stutenlent applies only to printers marketed in the U.S.A.
Statement of
The Canadian Department of Comaunications
Radio Interference Regulations
Thts dignal apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n’tmen pas de bruits radioelectriques dtpassant les limites applicables aux appareils numeriques de ia classe B prescrites dam le Reglement sur le brouillage radioelecrrique edicte par le minis&e des Communications du Canada.
Trademark Acknowlidgements
IBM PC,
Business Machines Corp.
Microsoft BASIC,
NOTICE
. All rights reserved. Reproduction of any part of this manual in any form whatsoever without STAR‘s express permission is forbidden.
. The contents of this manual are subject to change without notice.
. All efforts have been made to ensure the accuracy of the contents of this manual at the time of press. However. should any errors be detected. STAR would greatly appreciate being informed of them.
. The above notwithstanding, STAR can assume no responsibility for any errors in this manual.
0 Copyright 1989 Star Micronics Co., Ltd.
