Star Micronics NX-2415 user manual Top of form, Forward micro-feed, Reverse micro-feed

Top of form

When you turn on printer power, the top-of-form position is automatically set to the current position. If this is not where you want the top of the page to be, you can change the top-of-form position as follows.

1.Press the ( ON LINE >button to set the printer off-line.

2.Move the paper to the desired top-of-form position by pressing the GAPER FEED’) button, or by performing a forward or reverse micro-feed.

3.Press and hold the ( ON LINE ) button.

4.Press and hold the (PITCH)button.

5.Release both buttons at the same time. The printer will beep to indicate that the top-of-form position has been set.

Forward micro-feed

.	For fine alignment, you can feed the paper forward in very small increments
	as follows:
	1.	Press the (	ON LINE	> button	Loset the printer off-line.
	2.	Press the (	ON LINE	) button	again and hold it down.
	3.	Press the (PAPER FEED) button. The paper will start advancing in a series
		of small steps. When you want to stop, release both buttons.

Reverse micro-feed

You can also feed the paper in small increments in reverse, to return to a higher position on the same page.

Note:With fanfold forms, do not try to return to a previous page. The per- foration may catch inside the printer.

1.Press the ( ON LINE 1 button to set the printer off-line.

2.Press the ( ON LINE > button again and hold it down.

3.Press the ( =VBCCT ) button. The paper will start moving backwards in a series of small steps. When you want to stop, release both buttons.