Star Micronics NX-2480 Always load fanfold paper with the printers power turned OFF.

Loading paper from the rear of the printer
Always load fanfold paper with the printer’s power
turned OFF.
●
●
●
●
●
Place the stack of fanfold paper behind and below the
printer.
Pull the release lever at the right of the printer
towards YOU (p“ ).This releases the paper from the
platen and allows it to feed through the tractor roll-
ers.
Open the mute cover and the rear cover
Grip the gray tractor position locking levers on both
sides of the tractor unit and rotate the tractor unit as
far as it will go (about 20 degrees) so that the top is
tilted slightly towards you:
Open the tractor pin covers and align the holes in the
fanfold paper with the pins on the tractor unit. You
will probably need to slide the tractor pin units left
and right to align the paper properly. Use the gray
locking levers on each tractor pin unit to allow the
unit to slide left and right along the rail. Remember to
Page28