Loading paper from the bottom of the printer
Always load fanfold paper into the printer with the print-
er’s power turned OFF.
●Remove the front cover and the roller unit. See
“Removing the front cover” on page 10and “Removing
the roller unit” on page 13for details.
“Grip the gray tractor position locking levers on both
sides of the tractor unit. Rotate the front of the trac-
tor unit upward so that the top is horizontal.
.With astack of fanfold paper below the printer, feed
the top sheet of the stack through the feed slot at the
bottom of the printer and pass it over the platen.
●Open the tractor pin covers and align the holes in the
fanfold paper with the pins on the tractor unit. You
will probably need to slide the tractor pin units left
and right to align the paper properly. Use the gray
locking levers on each tractor pin unit to allow the
unit to slide left and right along the rail. Remember to
lock each tractor pin unit in place again when you
have finished moving it.
●Close the pin unit covers after you have made sure
that the paper holes are properly lined up with the
Page30