tractor pins. If the holes and pins are not correctly
lined up, you may find that the paper tears and jams.
Note: If the paper is too tightly stretched or too loose between the
pin holders, the paper will tear or jam as it is fed through the
printer. You may need to experiment to find the ideal tension.
s
●
●
●
Replace the roller unit (see “Installing the roller unit”
on page 12).
Replace all the covers that you have removed.
Turn on the printer.
Put the printer into not-ready mode (use the [~]
button) and use the [PAPER FEED] button to advance
the paper so that the print head isjust below aperfo-
ration. Put the printer into ready mode again.
Parking paper
Paper parking allows you to print single cut sheets even
when fanfold paper is loaded. The fanfold paper is tem-
porarily “parked” out of the way while the cut sheet is
fed through the printer.
Note: You can only use the paper parking function when fanfold
paper is loaded from the rear. You cannot use it when you are
feeding fanfold paper from the bottom slot.
●
●
9
The power should be ,ON.The release leaver shouldbe
pulled forward [~)and the fanfold paper loaded.
Put the printer into not-ready mode (use the (~]
button).
Tear off the last page of the fanfold paper. If the paper
is not in asuitable position to be torn off, use the
[PAPER FEED) button to feed the paper forwards to a
suitable position.
Page31