User Name, Password, Service Name | Star Tech Development BR4100DC

15

PPPoE

If your ISP uses the Point-to-Point over Ethernet (PPPoE) protocol to connect you to the Internet, you will be required to fill in the information below.

Parameter	Description
User Name	Enter your user name.
Password	Enter your password.
Please retype your password	Enter your password again for confirmation.
Service Name	Enter the service name (if required).
MTU	As an option, you can specify the maximum size of
	your transmission packet to the Internet. Leave this
	field blank if you do not wish to set a maximum
	packet size.
Maximum Idle Time	As an option, you can specify the idle time
	threshold (in minutes) for your WAN port. If the
	time period expires with no Internet activity, the
	router will automatically disconnect you from your
	ISP. Setting this value to “0” means that the router
	will never time out.
Auto-reconnect	When enabled, the router will reconnect a timed-out
	Internet connection when there is a request by the
	user to access the Internet.

When you are satisfied with your IP address settings, click the OK button. Congratulations! You have completed the basic router configuration required for a PPPoE connection. You will be taken to the router’s Status page. You can click Logout to begin accessing the Internet.

Image 17

Star Tech Development BR4100DC manual User Name, Password, Please retype your password, Service Name, Maximum Idle Time

Contents

Broadband Router FCC Compliance Statement Table of Contents Tools Minimum Requirements Introduction FeaturesBefore You Begin Back Panel ContentsRouter Basics Status Description Front Panel Getting Started Setting Up Your LANModem port is regular Modem port is uplink Straight Through Cross Windows XP Configuring Your PCsWindows Windows Me/98/95 WinNT Accessing the Router Home Navigate the Router Management Interface Time Zone Quick Setup Broadband Type MAC Address Cable ModemHost Name Subnet Mask Fixed-IP xDSLGateway IP Please retype your password PasswordService Name User Name IP Address Default GatewayUser ID Pptp Gateway General Settings Time Zone System Current Password Password SettingsNew Password Re-Enter Password Host Address Remote Management WAN Secondary DNS Address Domain Name Server DNSAddress Bridge Example Bridge Mode Dhcp Server IP Subnet MaskLease Time IP Address Pool Address Mapping Address Mapping Private IP Virtual ServerPrivate Port Type Example Virtual Server Trigger Port EnabledBetween 0 Trigger Type Example Special Applications Firewall Enable Client Filtering Access ControlPort Block Time Example Access Control Discard Ping from WAN DoS ProtectionRIP Defect Your E-mail Address Client IP Address Enable DMZPublic IP Address Status Cable/DSL Internet ConnectionGateway Primary DNS Firewall Device Status Security Log Security Log Dhcp Client Log Dhcp Client Log Backup Configuration ToolsRestore Restore to Factory Defaults Firmware Upgrade Firmware Upgrade Reset Appendix a Find and record your computer’s IP configuration settings Application Protocol Port Number Appendix BPopular Port Numbers Windows XP/2000 Setting a Static IP AddressAppendix C Windows NT Troubleshooting Test your Internet connection If problems persist, try resetting the routerPing your router Ping an outside IP address Forgotten Password Online Gaming ProblemsRemove your proxy settings Microsoft Internet Explorer 5.0 or higher Glossary Physical Address See MAC Address Network Mask See Subnet MaskPage Technical Specifications Technical Support Warranty InformationOn-line help Limitation of Liability Revised February 20