Stovax PR0919 manual Site Requirements/Installation, Appliance Location, Safety Precautions, Edge

INSTALLATION INSTRUCTIONS

SITE REQUIREMENTS/INSTALLATION

5.APPLIANCE LOCATION

5.1Please note this appliance has been specifically designed for stud work applications. There are two methods of installation, see Installation Instructions 3.2 Frame, 3.3

Edge

5.2This appliance must stand on a non-combustible hearth/ platform that is at least 12mm thick.

NOTE: It is recommended you construct the back panel of the fireplace from natural materials cut into three or more sections to prevent cracking. Resin-based materials may not be suitable. This appliance is an effective heat producer and attention must be paid to the construction and finish of the fireplace.

5.3A combustible shelf must be:

•maximum 150mm in depth

•minimum, 400mm high above the fire

A combustible side wall must be a minimum of 150mm from the appliance.

5.3This appliance can be installed with an up and out flue

(vertical wall - horizontal flue) or with a vertical flue with roof termination (see flue options, Section 2 Site Requirements).

IMPORTANT: REFER TO DATA BADGE AND TECHNICAL SPECIFICATION AT THE FRONT OF THE MANUAL TO ENSURE THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEGORY APPLIED IN THE COUNTRY OF USE.

FOR DETAILS OF CHANGING BETWEEN GAS TYPES REFER TO SECTION 10, SERVICING, ‘REPLACING PARTS’.

1.SAFETY PRECAUTIONS

1.1For your own and other’s safety, you must install this stove according to local and national codes of practice. Failure to install the stove correctly could lead to prosecution:

•Read these instructions before installing and using this stove.

1.2These instructions must be left intact with the user.

1.3Do not attempt to burn rubbish on this appliance.

1.4Keep all plastic bags away from young children.

1.5Do not place any object on or near to the appliance and allow adequate clearance above the appliance.

IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE APPLIANCE.

2. installation of the appliance

THERE IS AN OPTIONAL DUCT KIT, CODE No. 8572

WHICH CAN BE FITTED AT THE SAME TIME AS THE APPLIANCE INSTALLATION.

2.1Remove the appliance from the carton and discard all unnecessary packaging. Ensure no components are thrown away when unpacking.

2.2To open the glass door, use the allen key provided:

• Release the two window locks

The lock needs to be moved from shut to open towards the outer edge of the glass door, Diagram 1

1

AR1860

2.3The gas supply enters the fire through a silicon panel on the floor under the access panel, Diagram 2:

• Slit with a sharp knife before bringing through the supply pipe, Diagram 3

14