Sub-Zero 427G / 427RG, 424G / 424FSG manual Anti-TipBracket, Custom Panels, MODEL WS-30INSTALLATION

MODEL WS-30 INSTALLATION

Anti-Tip Bracket

CONCRETE WEDGE ANCHOR INSTALLATION

1Drill a 3/8" (10) diameter hole any depth exceeding the minimum embedment. Clean the hole or drill additional depth to accommodate drill fines.

2Assemble the washer and nut flush with the end of anchor to protect threads. Drive the anchor through the material to be fastened until the washer is flush with the surface material.

3Expand the anchor by tightening the nut 3–5 turns past hand-tight position or to 25 ft-lb of torque.

WARNING

Verify there are no electrical wires or plumbing in the area which the screws could penetrate.

CAUTION

Always wear safety glasses and use other necessary protective devices or apparel when installing or working with anchors.

Anchors are not recommended for use in lightweight masonry material such as block or brick, or for use in new concrete which has not had sufficient time to cure. The use of core drills is not recommended to drill holes for the anchors.

Custom Panels

For overlay and flush inset applications, custom door and grille panels must be installed. Panel size is critical for a proper fit. To verify panel requirements and dimensions, refer to the Sub-Zero design guide at subzero.com/specs.

IMPORTANT NOTE: Flush inset applications require a minimum 1/2" (13) reveal on all sides.

Finish all sides of the custom panel. They may be visible when the door is open or through the glass door.

CAUTION

A solid panel cannot be installed over the glass door.

subzero.com 25