MODEL 424G / 424FSG INSTALLATION
Custom Panel
MODEL 424G
For overlay applications, a custom door panel must be installed. Panel size is critical for a proper fit. To verify panel requirements and dimensions, refer to the
Finish all sides of the custom panel. They may be visible when the door is open or through the glass door.
The custom overlay door panel is attached using screws provided, through the door frame. Screw locations are marked on the back of the custom panel using tenon cen- ters inserted into holes of the door frame.
With the unit secured and door closed, hold the custom panel in desired position on the door. Lightly tap the front of the panel to locate mounting positions. Remove tenon centers. Refer to the illustration below.
The door frame has mounting holes to accommodate
To mount the custom panel, open the door and use pre- drilled holes to position the panel. Drive screws into the panel through black tape on the door frame. Screw holes are hidden behind the door gasket. Use as many screws as necessary to secure the custom panel. Refer to the illustra- tion below.
Adjustments can be made to the custom panel with a few mounting screws in place, but not fully tightened. Once the proper position is achieved, install and secure all screws.
Cover holes on the inside of the door frame with the cover patches or plugs provided.
CAUTION
A solid panel cannot be installed over the glass door. A solid door is available through an authorized
| DOOR |
PANEL | FRAME |
TENON CENTER
Tenon center.
GASKET | 13/32" (11) |
| |
| DIAMETER |
| GLASS |
| 1/4" (6) |
| DIAMETER |
Door frame cross section.
subzero.com 7