MODEL 427G / 427RG INSTALLATION
CONCRETE WEDGE ANCHOR INSTALLATION
1Drill a 3/8" (10) diameter hole any depth exceeding the minimum embedment. Clean the hole or drill additional depth to accommodate drill fines.
2Assemble the washer and nut flush with the end of anchor to protect threads. Drive the anchor through the material to be fastened until the washer is flush with the surface material.
3Expand the anchor by tightening the nut
WARNING
Verify there are no electrical wires or plumbing in the area which the screws could penetrate.
CAUTION
Always wear safety glasses and use other necessary protective devices or apparel when installing or working with anchors.
Anchors are not recommended for use in lightweight masonry material such as block or brick, or for use in new concrete which has not had sufficient time to cure. The use of core drills is not recommended to drill holes for the anchors.
Custom Panels
For models 427G and 427RG, custom panels and handle hardware must be installed. Stainless steel panels are available through an authorized Sub‑Zero dealer. For local dealer information, visit the find a showroom section of our website, subzero.com.
PANEL REQUIREMENTS
PANEL WEIGHT | MAX |
Door | 20 lb (9 kg) |
Drawer (427RG) | 12 lb (5 kg) |
PANEL THICKNESS | MIN |
All Panels | 5/8" (16) |
Reveals between panels can vary, 1/8" (3) reveals are typical.
CAUTION
When using a panel thicker than 3/4" (19) with reveal less than 1/4" (6), panel may cause damage to the unit when door is opened to 105°. Use the
CAUTION
As reveals between cabinetry and the unit decrease, severe finger pinching can occur while door is closing.
Finish all sides of the custom panel. They may be visible when the door is open or through the glass door.
CAUTION
A solid panel cannot be installed over the glass door. A solid door is available through an authorized
14