MODEL
Completion
HOME SECURITY CONNECTION
If the unit will be connected to a home security system, make connections to the leads shown in the illustration below. Refer to the following color codes:
•Normally open
•Normally closed
•
Use the spade terminals or wire nuts provided to make proper wiring connections.
CAUTION
The alarm circuit in the unit is intended as a low- voltage,
HOME SECURITY |
LEADS |
Home security connection.
ANCHORING
After the unit has been leveled and door adjustment com- pleted, anchor the unit to the opening to ensure a proper fit and secure installation.
To anchor the top of the unit, open the grille and install the screws provided, through the grille frame into cabinetry. There are several hole locations. Refer to the illustration below. Check for proper door clearance by opening the door.
To anchor the bottom of the unit, drive a screw through the side hole inside each roller base assembly. The screw will need to go in at an angle to attach properly. Refer to the illustration below. Additional material may be needed behind the cleat to ensure sufficient anchoring.
CAUTION
If the screws provided are not suitable for the installa- tion, use adequate screws.
ANCHORING
SCREWS
ANCHORING
SCREW
Top anchoring. | Bottom anchoring. |
30