Sub-Zero 424G / 424FSG, WS-30 manual Completion, Normally open contacts-whitewith red stripe wire

MODEL 427G / 427RG INSTALLATION

Completion

TRIM INSTALLATION

Install decorative trim strips to the top and sides of the unit. Attach the top trim using the double-sided velcro, then snap side trim over brackets on the sides of the unit. Refer to the illustration below.

HOME SECURITY CONNECTION

If the unit will be connected to a home security system, make connections to the leads shown in the illustration below. Refer to the following color codes:

•Normally open contacts—white with red stripe wire.

•Normally closed contacts—white with blue stripe wire.

•Common—gray with white stripe wire.

Use the spade terminals or wire nuts provided to make proper wiring connections.

CAUTION

The alarm circuit in the unit is intended as a low- voltage, low-current device only. It should not be used to switch line power. Any unused terminals should be completely insulated and all wires should be secured away from conductive or moving components.

	TOP TRIM
HOME SECURITY
LEADS	SIDE TRIM
Home security connection.	Trim installation.

KICKPLATE INSTALLATION

Install the kickplate using the screws provided. The mounting bracket may be adjusted slightly for a flush fit. The kickplate must be removable for service. The floor cannot interfere with removal. Refer to the illustration below.

A decorative kickplate can be added to the factory-installed kickplate but cannot block the kickplate louvers.

Turn power on by touching POWER on the control panel.

90° DOOR STOP

The door opens to 105°. A 90° door stop is built into the hinge system for installations where the door opening must be limited.

To engage the door stop, use a standard screwdriver and rotate the center cam of the hinge. The adjustment must be made to both upper and lower hinges. Refer to the illustra- tion below.

MOUNTING

BRACKET

Kickplate installation. 90° door stop.

subzero.com 17