MODEL
Panel Installation
GRILLE PANEL
Remove the bottom grille frame by extracting the lower two corner screws from each side of the grille assembly. Refer to the illustration below.
With the bottom section removed, slide the custom grille panel into the frame. If the panel is thinner than 1/4" (6), a filler material will need to be installed to achieve a proper fit. Once the panel is installed, reattach the bottom grille frame by sliding the corner brackets back into position, then reinstall the four corner screws.
SIDE PANEL
When installing a custom side panel, an accessory kit is required and is available through an authorized
IMPORTANT NOTE: The use of side panels may change the width of the opening.
A custom side panel must be a minimum of 24" (610) deep and 1/2" (13) thick. Routing will be necessary for the side panel to fit flush against the side of the unit. Refer to the illustrations below.
IMPORTANT NOTE: The height of the side panel will vary with the height of the grille. Verify the finished height before modifying panels.
BOTTOM |
GRILLE |
FRAME |
Grille frame assembly.
24" (610)
FRONT
OF SIDE
PANEL
ROUT TO 1/8" (3) |
|
|
|
| ||||
17/8"(48) |
|
|
|
|
|
|
| 84" |
|
|
|
| |||||
1" (25) |
|
|
|
|
|
| ||
|
|
|
|
| ||||
|
|
|
|
| (2134) |
4" (102)
OPTIONAL |
|
|
|
|
| 25/8" |
TOE KICK |
|
|
|
|
| |
|
|
|
| |||
|
|
| (67) |
Side panel dimensions.
1" (25) |
|
| 17/8" (48) |
1/8" (3) |
|
1/2" (13) |
|
MAIN | SIDE PANEL |
FRAME | ROUTING |
Routing detail.
subzero.com 27