SUPER MICRO Computer 1018D-73MTF PCI-E Slot SMB Enable I2C1/I2C2, LAN Port Enable/Disable

SUPERSERVER 1018D-73MTF User's Manual

PCI-E Slot SMB Enable (I2C1/I2C2)

Use Jumpers I2C1/I2C2 to enable PCI-E SMB (System Management Bus) support to improve system management for the PCI-E slots. See the table on the right for jumper settings.

LAN Port Enable/Disable

Use JPL1/JPL2 to enable or disable LAN Ports 1 and 2 on the motherboard. See the table on the right for jumper settings. The default setting is enabled.

Backpanel USB Wake Up Enable

Close pins 1/2 of jumper JPUSB1 to "wake up" the system when a device installed in USB 4 or USB 5 receives an incoming signal. See the table on the right for jumper settings.

Watch Dog Enable

Watch Dog is a system monitor that can reboot the system when a software appli- cation hangs. Close pins 1-2 of JWD1 to reset the system if an application hangs. Close pins 2-3 to generate a non-mask- able interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in the BIOS.

PCI-E Slot_SMB Enable

Jumper Settings

Jumper Setting	Definition
Pins 1-2		Enabled
Pins 2-3		Disabled

LAN Port En/Disable

Jumper Settings

Setting Definition

Pins 1-2	Enabled
Pins 2-3	Disabled

Backpanel USB Wake Up

Jumper Settings

Jumper Setting Definition

Pins 1-2	Enabled (Default)
Pins 2-3	Disabled

Watch Dog

Jumper Settings

Setting	Definition
Pins 1-2	Reset (default)
Pins 2-3	NMI
Open	Disabled

5-20