SUPER MICRO Computer 6113L-8, 6113L-i user manual Control Panel, Chassis Front and Rear Views

SUPERSERVER 6113L-8/6113L-i User's Manual

CD-ROM Drive USB Ports COM Port Control Panel/System LEDs

SCSI/IDE Drives System Reset Main Power

VGA Port PCI-X Slot

COM1 Port	USB Ports Ethernet Ports External SCSI Port
	(6113L-8 only)

Figure 6-1. Chassis: Front and Rear Views

6-2 Control Panel

The control panel (located on the front of the chassis) must be connected to the JF2 connector on the serverboard to provide you with system status indications. A ribbon cable has bundled these wires together to simplify the connection. Connect the cable from JF2 on the serverboard to the appro- priate header on the Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess cabling out of the airflow path.

The control panel LEDs inform you of system status. See "Chapter 3: System Interface" for details on the LEDs and the control panel buttons. Details on JF2 can be found in "Chapter 5: Advanced Serverboard Setup."

6-2