C2SEA/C2SEE User’s Manual
XAdvanced Chipset Settings
The items included in the Advanced Settings submenu are listed below:
XNorthBridge Configuration
This feature allows the user to configure the settings for the Intel 945GME NorthBridge chipset.
Memory Remap Feature
PCI memory resources will overlap with the total physical memory if 4GB of memory or above is installed on the motherboard. When this occurs, Enable this function to reallocate the overlapped physical memory to a location above the total physical memory to resolve the memory overlapping situation.The options are Enabled and Disabled.
PCI MMIO Allocation
Use this feature to assign the address for PCI
DRAM Frequency
This feature allows the user to select the DRAM Frequency setting. The options are Auto
Configuring DRAM Timing by SPD
Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip which is built in the memory module in order to get the exact memory specifica- tions. The options are Enabled and Disabled.
Memory Hole
Use the feature to allocate memory resource reserved for use of PCI devices. If set to 15 MB~16MB, the reserved memory will be placed in the location around 15 MB~16 MB. The options are Disabled and 15 MB~ 16 MB.
Initiate Graphic Adapter
Use the feature to select the graphics controller to be used as the primary boot device. The options are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI.
IGD Graphics Mode Select
Use the feature to set the amount of system memory to be used by the Internal Graphics Devices. The options are Disabled, Enabled 32 MB, Enabled 64 MB, and Enabled 128 MB.
