![](/images/new-backgrounds/1267459/26745921x1.webp)
Chapter 1: Introduction
Quick Reference (i2DMR-8G2/i2DMR-iG2)
(*Please refer to Chapter 2 for pin definitions and detailed information.)
Jumper | Description | Default Setting | |
CN1, CN3 | SCSI Cha.A(CN3)/Cha.B(CN1)Termination (*Note4) | ||
|
|
| Open (Enabled) |
J7 | GLAN Enable/Disable | Pins | |
J31 | Watch Dog | Pins | |
JBT1 | CMOS Clear | (*Note 4) | |
JA1 | SCSI Enable/Disable (*Note5) | Pins | |
JV1 | VGA Enable/Disable | Pins | |
Connector |
| Description |
|
Alarm Reset (CN5) | Fail Alarm Reset Switch |
| |
| |||
Chassis Intrusion (J25) | Chassis Intrusion Header |
| |
COM1 (J5), COM2 (J38)COM1 & COM2 Serial Port and Header | |||
CPU1(J30), CPU2 (J29) | CPU 1/2 Sockets |
| |
Memory (RAM) Slots:DIMM1(J16),DIMM2 (J13), | |||
|
| DIMM3 (J11), DIMM4(J9), DIMM5 (J15), | |
|
| DIMM6 (J14), DIMM7 (J12), DIMM8 (J10)(*Note 2) | |
Fan Headers |
| ||
Front Panel CTRL (U66)Front Control Panel Connector (*Note 3) | |||
IDE1 (J37), IDE2 (J35) | IDE1/2 Hard Disk Drive Connectors | ||
IPMI (J26) |
| IPMI 1.5, 2.0 Connector |
|
ITP (J34) |
| ITP Connector (For Testing Only) | |
|
| ||
PWR1(J20), PWR2(J36) Power1 and Power2 | |||
PWR Fault (U62) | Power Fault Connector |
| |
Speaker (CN4) |
| Speaker Connector(*Note3) |
|
SMB (J22) |
| System Management Bus Connector | |
SMB_Power (J27) | System Management Bus Power Header | ||
SCSI A&B (J18,J3) | SCSI A Connector(J18), SCSI B Connector(J3) | ||
|
| (*Note 4) |
|
USB 0/1(J1),USB2/3(J4)Back Panel Universal Serial Ports | |||
USB4/5 (J21) |
| Front Panel USB Headers |
|
VGA Connector (J2) | VGA Connector |
| |
WOR (J6) |
|
|
(*Notes: 1. For 1U servers, use Fan1&Fan2 for CPU cooling. For 2U servers, use Fan1, Fan2, Fan3, Fan4 for CPU cooling.
2.See Chapter 2 for Memory Installation Instructions.
3.See Chapter 2 for detailed information.
4.For