Tamron IC-R10 Program scan, Start and stop scanning, Select program scan channel

■Program scan

SCANNING OPERATION 5

2. Start and stop scanning

This is the most useful basic scan for searching over a spec- ified frequency range.

1. Select program scan channel

qPush [V/M] to select VFO mode (p. 11).

Push [SCAN] to start scanning.

SCAN

VFO

FM

144.0000

Flashes while scanning

w While pushing

[FUNC], push

FUNC

+

VFO

FM

PROGRAM SCAN

To change the direction of the scan, rotate [DIAL] during scanning.

[(4)PROG-S].

Rotate [DIAL] to se- lect the program scan channel.

PROG-S

4

[DIAL]

00

VFO

FM

PROGRAM SCAN 02

When the program skip function is ON (p. 61), fre- quencies stored in BANK R memories are skipped. Also, “SKIP” is displayed.

VFO

FM

144.0000 SKIP

Skip indicator

Push [CLR] or [SCAN] to stop scanning.

Displays “PROGRAM SCAN” with program channel number and the names for 2 sec., then scan edges, “S” and “E”, are dis- played.

VFO

FM

S:144.0000

E:146.0000

Displays "S (start)" and "E (end)" frequencies after 2 sec.

When the same frequency is stored in both scan edges, program scan will not proceed.

The default frequency range is 144.0000–146.0000 MHz. Set up scan frequency ranges before starting pro- gram scan. See page 57 for program scan channel set up.

40