Tamron IC-R10 Set SIGNAVI function, Signavi, Select scan type and start scanning, 144.0000

■SIGNAVI function

The SIGNAVI function activates while paused during full, program or auto- memory write scans in FM mode. It searches for busy frequencies up to 100 kHz* (+100 kHz when scanning up, –100 kHz when scanning down) from the paused frequency (f0), then jumps to the next busy frequency (f1) detected (by SIGNAVI) when scan resumes.

*The SIGNAVI search range varies ac- cording to tuning step settings. The maximum range is 5 channels or steps from the receive frequency, therefore, the tuning step must be equal to or smaller than 20 kHz.

1. Set SIGNAVI function

qPush [V/M] to select VFO mode (p. 11).

wWhile pushing [FUNC], push [(6)SIGNAVI].

•Displays “SIGNAVI” below fre- quency.

FUNC	VFO
SIGNAVI	FM
	144.0000
+
6	SIGNAVI

SCANNING OPERATION 5

2.Select scan type and start scanning

1While pushing [FUNC], push [(4)PROG-S] for program scan or [(5)AMWS] for auto-memory write scan, then rotate [DIAL] to select scanning frequency band.

•Confirm that the receive mode of the selected scan band is FM and also that the tuning step is equal to or smaller than 20 kHz.

•If you want to search the entire frequency range (0.5–1300 MHz) skip this step.

2Push [SCAN] to start scanning.

SCAN VFO

FM

144.0000

Flashes while scanning

3Push [SCAN] or [CLR] to stop scan- ning.

46