Tamron LS6 quick start Editing Label Mode, Mode Description Applications, Using Printer Utilities

SETTING UP THE VIPER™ LS6

Editing Label Mode

To edit the label mode, press to enter the setup menu and:

1.Use the up or down directional arrows to highlight Mode.

2.Use the right or left directional arrow keys to change the mode.

3.Press the key to select the desired mode. A check mark icon will appear next to the selected mode.

4.Press the key to accept the changes and return to the home screen.

MODE	DESCRIPTION	APPLICATIONS
Component	Vertically centers legend	Electrical components
Wiremarker	Repeats legend until label is filled	Wire and cable marking
Terminal	Places legends at terminal	Terminal blocks
	locations
Tape	Rotates legends 90°	Safety/facility ID, pipe
		marking
Strip	Repeats legend until label is filled	Wire and cable marking
	and copies legend on two sides of
	middle perforation
Network	Places legends at port locations	Data communications
		components

Using Printer Utilities

To use printer utilities, press to enter the setup menu and:

1.Use the up or down directional arrows to highlight Utilities.

2.Use the right or left directional arrow keys to change the utilities setting.

3.Press the key to select the desired utility. A new screen will appear indicating either Battery, ViperLink, or Remote Printer.

The Battery utility is used to charge the battery. See section entitled “BATTERY INFORMATION” on pages 9-11.

The ViperLink utility is used to interface with ViperLink ™ software. See sections entitled “INTERFACING WITH A COMPUTER” and “VIPERLINK” on pages 49-52.

45